6mm ID Pressing Die Set w/ 2 Push Rods

    A$ 439.00 A$ 439.00 439.0 AUD

    A$ 439.00

    Incl. GST

    This combination does not exist.

    Add to Cart

    SKU# SDS6


    Terms and Conditions
     

    A set of 6mm diameter (ID) hardened steel dry pressing die set for pellet presses, ready for you to make 6mm diameter cylinder-shape pellets.

    Specifications

    • Maximum Pressure:      4 tons
    • Rockwell Hardness:       Rc 62
    • Diameter (ID):              6 mm
    • Height:                        47 mm (assembled without sample)
    • Sleeve Height:              25 mm
    • Sleeve Diameter (OD):  25 mm
    • Tolerance:                   0.01-0.02 mm (10-20 micron)
    • Max sample fill height:  Not to exceed 1/3 of the sleeve height
    • Material:                      W18Cr4V hardened carbon tool steel

    Die set includes

    • Three 6mm ID cylinder-shape core dies made of polished hardened steel
    • One steel sleeve
    • One steel support plate
    • Two push rods
    • One pellet ejector

    Important

    • Always wear protection goggles during operation
    • Clean the die set throughout with absolute ethyl alcohol and keep them in a dry box with silica gel after use to avoid rusting on the surface.
    • Never fill the die more than 1/3 its sleeve height with your sample and do not apply pressure beyond 4 tons. Across International is not responsible for any damage caused by misuse.

    Recently viewed Products