6mm ID Pressing Die Set w/ 2 Push Rods

A set of 6mm diameter (ID) hardened steel dry pressing die set for pellet presses, ready for you to make 6mm diameter cylinder-shape pellets.

Specifications

• Maximum Pressure:      4 tons
• Rockwell Hardness:       Rc 62
• Diameter (ID):              6 mm
• Height:                        47 mm (assembled without sample)
• Sleeve Height:              25 mm
• Sleeve Diameter (OD):  25 mm
• Tolerance:                   0.01-0.02 mm (10-20 micron)
• Max sample fill height:  Not to exceed 1/3 of the sleeve height
• Material:                      W18Cr4V hardened carbon tool steel
  

Die set includes

• Three 6mm ID cylinder-shape core dies made of polished hardened steel
• One steel sleeve
• One steel support plate
• Two push rods
• One pellet ejector

Important

• Always wear protection goggles during operation
• Clean the die set throughout with absolute ethyl alcohol and keep them in a dry box with silica gel after use to avoid rusting on the surface.
• Never fill the die more than 1/3 its sleeve height with your sample and do not apply pressure beyond 4 tons. Across International is not responsible for any damage caused by misuse.