30mm Diameter ID Dry Pressing Die Set

A set of 30mm diameter (ID) hardened steel dry pressing die set for pellet presses, ready for you to make 30mm diameter cylinder-shape pellets.

Specifications

• Maximum Pressure:      40 tons
• Rockwell Hardness:       Rc 62
• Diameter (ID):              30 mm
• Height:                        110 mm (assembled without sample)
• Sleeve Height:              60 mm
• Sleeve Diameter (OD):  48 mm
• Max sample fill height:  Not to exceed 1/3 of the sleeve height
• Material:
  • Core die & push rod:          W18Cr4V hardened carbon tool steel
  • Sleeve, ejector & support:  Cr12 hardened carbon tool steel
    
• Tolerance:                   0.01-0.02 mm (10-20 micron)

Die set includes

• Two 30mm diameter cylinder-shape core dies
• One sleeve
• One support base
• One push rod
• One pellet ejector

Important

• Always wear protection goggles during operation
• Clean the die set throughout with absolute ethyl alcohol and keep them in a dry box with silica gel after use to avoid rusting on the surface.
• Never fill the die more than 1/3 its sleeve height with your sample and do not apply pressure beyond 40 tons. Across International is not responsible for any damage caused by misuse.